PoE Switches
Cameras, access points, validators, and terminals powered from the closet over the cable that carries their data. PoE switches run from 8 to 48 ports, with PoE+ (802.3at) on every port and PoE++ (802.3bt) on units built for high-draw devices.
Paygasus carries Peplink and Ericsson Cradlepoint PoE switches, and more.
Total power budgets run from a few hundred watts to over 700, sized for a full rack of cameras and access points drawing maximum power at a cold start. Gigabit, 2.5G, and 10G ports carry the traffic from Wi-Fi 6 access points and high-resolution cameras, and SFP+ fiber uplinks reach the router across a lot, platform, or building.
Browse the products below or request a quote that sizes the port count, budget, and uplinks to the site.
- ✔ 8 to 48 port switches from the authorized source, with the manufacturer warranty
- ✔ Port count, PoE budget, and uplinks sized to the site
- ✔ Talk to a specialist before buying
- ✔ Shop all switches
Sizing the PoE Budget
Add the rated draw of every powered device on the switch, then leave headroom for growth and for cold starts, when every device draws its maximum at once. The product page lists each switch's total budget and per-port maximum. A switch short on budget powers down the lowest-priority ports first, which makes the budget matter more than the port count.
- ✔ PoE+ (802.3at) delivers up to 30 watts per port for cameras, indoor access points, phones, and validators.
- ✔ PoE++ (802.3bt) delivers up to 60 or 90 watts per port for pan-tilt cameras, outdoor access points, small displays, and other high-draw devices.
Ports, Speeds, and Uplinks
- ✔ 8 ports for a kiosk cabinet, small office, or single charging site.
- ✔ 24 ports for a depot floor, branch office, or admin building.
- ✔ 48 ports for a large building or venue closet.
- ✔ Gigabit, 2.5G, and 10G ports, with the multi-gig ports placed where Wi-Fi 6 access points and 4K cameras connect.
- ✔ SFP+ uplinks for fiber to the router or between closets, with the module type listed per unit.
Cloud Management on Every Port
Each switch reports to its manufacturer's console, the same console that runs the router. Ports can be labeled, grouped into VLANs, scheduled to power down overnight, and power-cycled remotely when a camera or access point hangs. Where several sites share the same layout, the configuration is set once and pushed to each.
Frequently Asked Questions
How many watts does a site need?
Sum the draw of every device, add headroom, and check the total against the switch's budget on the product page. A Paygasus specialist can run the count from a device list.
Can a PoE++ switch power PoE+ devices?
Yes. The switch negotiates the power each device requests, and a PoE++ port powers any PoE+ or PoE device.
Do these switches need a subscription?
Cloud management requires a console plan on most units. The product page states whether a term is included or sold separately.
Can the switch sit in a different building from the router?
Yes, over an SFP+ fiber uplink. The module and fiber type are listed per unit.
When does a site need a rugged switch instead?
Anywhere without climate control, such as roadside cabinets, platforms, and vehicles. See Rugged Switches.